MicroE Systems Mercury 1000 Installationshandbuch

Taking Control of MotionMercury™2000, 3000 & 3500SSmmaarrtt PPrrooggrraammmmaabbllee EEnnccooddeerr SSyysstteemmssIInnssttaallllaattiioonn MMa

Reference SectionInstallation of Linear Scales Page 8MicroE SystemsL0.2L0.6L0.2LBenching pinsPositioning the ScaleNote: Before beginning mount

Reference Section Sensor mounted with good electrical contact to a well-grounded surface (preferred)1. 15-pin D-sub connector grounding: The encoder&a

Reference Section Page 10Mercury 3500, 3000, 2000 Signal Twisted PairA+ Pair 1A-B+ Pair 2B-Index+ Pair 3Index-+5V Pair 4GNDCustomer Interfa

Page 11SmartSignal Module Mounting OptionsDeclaration of CE ConformanceThe SmartSignal electronincs module may be mounted directly to a bulkhead conne

TroubleshootingProblemThe Power/Calibration indicator will not come on.Solution• Make sure that the SmartSignal electronics’ 15-pin D-sub connector is

World Headquarters: 8 Erie Drive • Natick • MA 01760www.microesys.com • [email protected] • T. [800] 355-4047 • F. [508] 655-7084 Thank you

Don Mitchell Founder, Chairman and Chief Technology OfficerMicroE SystemsicroE Systems was founded to advance encoder technology to a level neverbef

Table Of ContentsSYSTEM ILLUSTRATION PAGEEncoder with Linear scale 2Encoder with Rotary scale 3INSTALLATION INSTRUCTIONSEncoder System Mounting - Li

Mercury 2000, 3000 & 3500 Encoder System with Linear scaleEExxppaannddeedd VViieewwScale benching edgeEnd locator pinEnd index markSensor mountin

Mercury 2000, 3000 & 3500 Encoder Systemwith Rotary scaleDouble shielded cableThumb screwSSyysstteemm VViieewwShown with Rotary scaleSensor(shown

Installation InstructionsLinear Encoders12Attach the scale to the baseslide. Reference the preferreddatum on the interface drawingfor either end or ce

Installation InstructionsLinear Encoders5If benching dimensions cannot be provided, proper sensor alignment may require minor adjustments to the senso

Installation InstructionsRotary EncodersAttach your hub/scaleassembly to the rotarydevice. Refer to theinterface drawing. Thereflective surface of the

Installation InstructionsRotary EncodersPage 76Confirm proper alignmentover the full range of motion. The “Proper Alignment” LEDmust remain on over th